Topic Options
#6240 - 03/04/10 09:22 PM Nitro does not save Patch in Cubase
Barney Offline
New Member

Registered: 02/18/10
Posts: 1

An interesting one. I have used Nitro on a few tracks in Cubase. When I re-visit these tracks later, I note that the Nitro pre-set I have been using reverts to bank A1 when I re-load the song.

So an example is that on a given song I mix with Nitro on bank B12 to get the right sound.
When I re-load the pre-set reverts to A1.

Different sound (!)

Does anyone have any ideas? All other plug-ins in the songs remember the settings across saving and re-loading



#6394 - 06/09/10 04:02 AM Re: Nitro does not save Patch in Cubase [Re: Barney]
Hubert Pietrzykowski PSP Offline


Registered: 08/21/02
Posts: 308
Loc: Warsaw
The fact that it reverts to A1 is intentional - Nitro only exposes one preset slot to the host, so whenever you open the session it will be A1 that is active. However, the settings of the preset of your choice (the active one on session save) should be restored in slot A1, so you should get the same sound. Are you able to identify the parameters that change their values over save/load? Or maybe everything is different?
Hubert Pietrzykowski
DSP Engineer